SAXBY WP422 2 gang outdoor socket IP66

SAFETY WARNING

• Ensure the mains isolator is switched off at the consumer unit before commencing works. If in doubt consult a qualified electrician. Further informationis available online. Wiring should be installed in accordance with the latest edition of the IET regulations BS7671.
• The total load on the circuit may not exceed the rating of the circuit cable, fuse or MCB once the switch plate is installed. The circuit must be protectedbyanappropriate fuse, , RCD (Residual Current Device) or circuit cable.
• For security to prevent unwanted tampering of the switch/socket, the cover has a lug which features a 6mm hole which can accept a padlock or similar lockingsecurity device (not supplied). This product is IP66 and must be earthed.
• EARTH = GREEN/YELLOW NEUTRAL = BLUE / pre-April 2004 BLACK LIVE = BROWN / pre-April 2004 RED

INSTALLATION INSTRUCTION

• An outdoor location should be chosen ensuring adequate access to a mains supply circuit. The unit should be mounted on a clean, rigid vertical flat surfacesuitable to accept screw type fixings as unevenness can cause product damage or affect operation.
• Remove front assembly from the back box. Mark the location, using the backbox as a template and drill the fixing holes. Note – the drilling of the drainholewill reduce the IP rating of the unit. Only one 3-5mm drain hole position can be drilled. If using conduit to the bottom entry, the drain hole should be drilledtothe lowest point of the conduit run not in the back box. If metal conduit is used, earth continuity across the conduit must be maintained using appropriateconnections.
• Ensure adequate excess lengths of cable for connection to switch or socket, remove pre-fitted blanking plugs as required by pushing out fromthe insideandinstall a suitable IP gland (not supplied). For rear entry, cut or drill a 20/25mm hole and install a suitable IP rated grommet (not supplied). Only removetheblanking plugs for positions used.
• Feed the mains cable to the unit and secure the back box to the surface. The fixing holes are slotted to allow some rotational adjustment if required. Wiretheswitch/socket as diagram below. Ensure the polarity is observed correct. L – Live (brown), E – Earth (green/yellow), N – Neutral (blue). The switch/socket maybe removed from front assembly to aid wiring process.
• Check all connections are secure with no loose strands. An earth connection must be made to an earth terminal of the socket. All bare wires must be sheathed. An earth terminal in the back box is provided if required.
• Fit the socket/switch front assembly ensuring the gasket is not pinched or damaged. Take care not to compress, damage or trap any cables. Secure front assembly with screws provided and do not over tighten. Switch on and check operation. The cover will seal regular sized UK plugs. Cover must be closedandsecured when not in use.

VOLTAGE

• Voltage : 220-250V ac Frequency : 50/60Hz
• Socket Terminal Capacity : 3 x 2.5mm², 3 x 4mm², 2 x 6mm²
• Switch Terminal Capacity : 3 x 2.5mm², 3 x 4mm², 1 x 6mm²
• Fuse Terminal Capacity : 4 x 2.5mm², 3 x 4mm², 2 x 6mm²
• IP Rating : IP66 (when cover securely closed)